NURTURALLY BABY ANTI ROLL SUPPORT

Nurturally's patented Baby Anti Roll Support design has been developed to keep babies in the preferred back position.

Born from a real story of a dad that saw his 6-months-old daughter lying face down in her crib (find the full story here), the Nurturally Baby Anti Roll Support is suitable for when the baby can roll from a position on his back to his front, but can't yet roll back (between 3 and 6 months old).
USE UNDER ADULT SUPERVISION ONLY.

20% off on Black Friday Week

$23.95
$19.16

Available on Amazon

SHOP NOW

DESIGNED TO BE SAFE.

The elastic loop is strapped around the crib bars, it pulls enough on the cloud section to create a slight cantilever effect leaving the device standing semi-horizontal at about 6” above the mattress like a stiff flag on a pole, instead of it hanging down and flopping around where the baby will constantly try to bite it or wrap it around themselves.
The main body is breathable to avoid suffocation.

CHILD SAFETY CERTIFIED.

This product complies with EN71 (EU), ASTM and CPSIA (USA) Child Safety Standards.
ONLY TO BE USED UNDER ADULT SUPERVISION

ELASTIC ENOUGH TO ALLOW FREE MOVEMENT.

 It has just the right amount of elasticity to allow a lot of free movement and to avoid sudden jerk and clips tearing out when the baby tries to roll, but not enough to allow baby to roll over.

EASY TO USE IN ANY CRIB.

 The device will be installed on the two sides of the crib, around the crib bars, wrapping each product around the bar and passing clip and cloud through the elastic loop, and clipping the clouds below the hip area as shown in the instructions, out of reach of the child's hands.

20% off on Black Friday Week

$23.95
$19.16

Available on Amazon

SHOP NOW

CLIPPING

Fold the fabric of the sleeping sack as thick as possible to be .25" to .35" (6.5 mm to 8.5 mm)

POSITIONING

Clip the clouds below the hip area as shown in the image, out of reach of the child's hands.

INSTALLATION

1. Place the cloud through the bars of the crib.

2. Wrap the product around the bar and pass the clip and cloud through the elastic loop.

3. Pull the cloud through the elastic loop.

4. Pull the cloud to tighten the loop.
The elastic loop should be at at least 6" (15 cm) above the mattress of the crib.

DESIGNED IN NEW YORK BY CHROME CHERRY - PATENT PENDING